starsk

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • 2019-03-17 at 08:49 in reply to: Zarplotter 4-motor drawing machine #22155
    starsk
    Participant

    Hello @dan. Do you know if the zarploter can be rectangular. or the motor have to be in a square localization

    2019-03-13 at 11:00 in reply to: Zarplotter 4-motor drawing machine #22132
    starsk
    Participant

    Thanks Dan. But could you tell me if you have a cable digram of the motors to the drivers?. are the motors switch ? I mena the motors are reverse?
    could you send or post a picture of your motors connections on one of your cable bots?

    Thanks Dan

    2019-03-13 at 01:23 in reply to: Zarplotter 4-motor drawing machine #22126
    starsk
    Participant

    Hello @dan. I am following you project. I already have the list of materials. Could you tell me . where I can find a diagram that explain the connections of zarploter?

    Thanks

    2019-03-13 at 01:22 in reply to: Zarplotter 4-motor drawing machine #22125
    starsk
    Participant

    Hello Dan. I am following you project. I already have the list of materials. Could you tell me . where I can find a diagram that explain the connections of zarploter?

    Thanks

    2018-06-28 at 13:50 in reply to: ZARPLOTTER Makelangelo 5 FIRMWARE #20224
    starsk
    Participant

    Hello. I am looking if somebody can help to understand why the extruder driver is giving me more rotation that the XYY drivers (I am using Ramps).

    Can I change this in the Firmware.

    Thanks

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)