post

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2018-12-01 at 00:46 in reply to: Push the scroll button on the lcd to start a drawing #21273
    post
    Participant

    there is a M226 in the gcode so I think it is missing something in the firmware.

    2018-11-30 at 11:30 in reply to: ZARPLOTTER Makelangelo 5 FIRMWARE #21268
    post
    Participant

    Hi
    It was a bad cabel connector on one of the motors;)
    works fine now

    2018-11-27 at 12:51 in reply to: ZARPLOTTER Makelangelo 5 FIRMWARE #21233
    post
    Participant

    Hi

    I am building a Zarplotter and are using a ramps 1.4 board. motor xyz are working as they should but the motor I have connected to the E0just vibrate back and forth when i move the plotter head or starting a drawing. it seems like it get confused on witch direction it should go.
    any suggestions?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)