Josef Rozinek
Forum Replies Created
-
AuthorPosts
-
Josef RozinekParticipant
Following all the notes and the Dozuki I reinstalled everything and I am drawing again!!
Where in North Van do I drop off the beer? 😀Now for some reason lot of the controls in the software have a “Missing:” prefix to it, any ideas why?
Josef RozinekParticipantHi Dan,
I figured it thinks it is at the top, since the gondola shows on top edge of paper after homing, even though it is physically at the bottom.
My latest attempt went this way:
I reflashed the machine with the latest firmware. Makelangelo 5+.
Upon pressing “Find home” it goes all the way to endstops nice and fast and that is it.
Then upon pressing “Go home” is when it get’s weird.
It takes about 2 minutes at an extreme slow snails pace to take the weights from endstops pressed to a position 2″ below, see pic:
How is the homing sequence supposed to go?
J.
-
AuthorPosts