Makelangelo Assembly Instructions Conflict

Shop › Forum › Makelangelo Polargraph Art Robot › Makelangelo Assembly Instructions Conflict

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2014-01-28 at 01:29 #5945
    Anonymous
    Inactive

    I just received my DIY kit, and I’m confused about the 12v/5v jumper on the adafruit circuit board. Your written instructions say

    “Remove the jumper on the adafruit shield next to the M+/GND.”

    Your box assembly video says to install the same jumper.

    Which is it?

    2014-01-28 at 02:56 #6433
    Anonymous
    Inactive

    Hi!

    The jumper should be ON. Can you tell me the URL where you saw the mistake? I’ll correct is ASAP.

    Thank you 🙂

    2014-01-28 at 15:32 #6432
    Anonymous
    Inactive

    I’m not able to access the erroneous page. The same link I used to get there now directs me to the GitHub page, which now shows the correct instruction “jumper on”. Thanks for the quick answer.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.