Accessing g-code
- This topic has 1 reply, 2 voices, and was last updated 9 years, 4 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Ok, so this is a stupidly simple question. We are not coders, but we get by. I’m trying to figure out how to access the g-code for Makelangelo so we can make changes to respond to input from a sensor. How do we get into the code?
Makelangelo firmware is available by donation from our website: https://www.marginallyclever.com/product/makelangelo-firmware/
You can also find it on our github page: http://www.github.com/marginallyclever/
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
