[Joyer]

1/ I will check a long click.
2/ during drawing when START to WORK THE SERVOMOTOR and pen is up and down the program is off . The cables are ok.

[Joyer]

Dan, I need help again.
1 / I still have problem with the encoder in my Arduino Mega 2560 board with ramps 1.4.
(LCD 128X64 Full Graphic Smart LCD Controller Sd card)
If I want to go to the next item I have to click two or three times for it to work. Clicking once doesn’t work.

2 / When the pen draws and must go up over the paper, there is a loss of communication with the program.

[Joyer]

Hello Dan,
 I have a problem with my properly working Makelangelo
  and I have questions for you
can you help because I don’t know what to do?
1. After entering the sub-menu of the SD card, the subtitles are displayed only when the encoder is moved, but only for 0.5 sec (like blinking), then appear and disappear.
2. On the submenu from SD Card – the program can sometimes hang – complitly stop.
  Where should I look for errors?
3. The gondola always draws a picture inverted by 90 degrees. I am preparing a draw in the program on a computer (standard horizontal subtitles), saving it to an SD card. I start drawing on the device and it prints with a 90 degree shift to the right.
I tried to change the engines for the cross, but the image is still inverted by 90 degrees and is also a mirror image.

4. Encoder problem. The encoder works almost normally on the main menu, but with entry to any submenu must do a lot of arounding to jump down one checkbox. Go to up there is not such problem.

[Joyer]

Thank you Dan, but I asked, which version of Arduino will be the most compatible with your software Marginally Clever-Makelangelo-9.0.1

[Joyer]

Dan, thank you so much for helping and Makelangelo firmware (v9.0.1) Makelangelo software (v7.20.1). Now I start with instalation and trying. What Arduino version the best for instalation?

[Joyer]

Makelangelo firmware (v9.0.1) Makelangelo software (v7.20.1) – I understand, it is all what I need. Thank you for info, when you answer me, I will go to your webpage for order with a voluntary donation. Thank you onesmore.

[Joyer]

Hello, Dan, I do not have any installation program.
Can you sell me only software – the latest version?

[Joyer]

Dan, thank you for informations., Where I can download? Is it?
Makelangelo firmware /board_ramps.h
https://github.com/MarginallyClever/Makelangelo-firmware/blob/master/board_ramps.h

[Author]

Posts