Stewart Platform: testing stepper motors
- This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Are all six motors supposed to move when installing test_steppers_rumba.ino, since only the motor connected to the first terminal moves? I am also having trouble installing firmware_rumba_minimal.ino, it is timing out and not uploading. Could that be related to the fact that all six motors might be supposed to turn when installing test_steppers_rumba.ino?
test_steppers_rumba.ino It will move each motor one at a time. So when it finishes moving motor 1 then it will repeat the same behavior on motor 2 etc. When all 6 are done it will loop and repeat.
I think it’s the USB cables that I’ve got that are being troublesome. I’m going to try a new supplier and see if that makes things better.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
