Stewart platform steppers not moving

Shop Forum Stewart/Gough Platforms Stewart platform steppers not moving

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #12842
    Anonymous
    Inactive

    Hello,

    I have tried running the Stewart platform with the code provided but only stepper 5 and stepper 6 are moving. Does anyone know why this is happening?

    #12843
    Dan
    Keymaster

    Post a picture of your setup?

    #12849
    Anonymous
    Inactive

    I have figured out the issue. I think 4 out of 6 drivers have burned out somehow so only 2 of the motors are working. I couldn’t figure out a way to post the picture of my set up but would I be able to buy the drivers alone through your website?

    #12850
    Anonymous
    Inactive

    Is this board identical to the one that you have used in the Stewart platform?
    RUMBA Board incl. 6 A4988 driver and Wire Pack

    #12851
    Anonymous
    Inactive

    I found the drivers: Set of (5) A4988 Pololu compatible driver
    Would I be able to use these to replace the drivers that you used in the Stewart platform? I apologize for my millions of emails

    #12852
    Anonymous
    Inactive

    I just checked they’re the same haha I’m crazy.. Thank you!

    #12896
    Dan
    Keymaster

    Yes, the A4988 drivers are what we use in the RUMBAS for the Stewart Platform.

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.