Problems when using machine custom
- This topic has 1 reply, 1 voice, and was last updated 6 years ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
VER 7.23
I increased the machine width from 650 to 1000.
but
Even if the width and height of the machine are set differently, the gcode does not change according to the position change, so it is not drawn normally.
and
Can I use the endstop option when using custom?
After changing the machine size you’ll have to reload the image to see changes. Also remember to adjust “resize to fit paper” option, otherwise it should stay at the original size.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
