makelangelo 2 gcode command line?
- This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
On the gcode tutorial there are instructions that ask the user to enter commands, however the software does not allow commands to be entered.
“Type in this command and you’ll see the help message again.”
I cannot type in…
Does anyone know how to get the geode to talk to the arduino?
I’ve been meaning to add an “advanced mode” where you could do this. Might help some people with debugging, too.
Let me see what I can do.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
