Machine width in Makelangelo 7.282

Shop Forum Makelangelo Polargraph Art Robot Machine width in Makelangelo 7.282

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #30004

    Hi all,
    I have a plotter with a huge machine width of 1720 mm. In Marlin firmware I have set the X_BED_SIZE to 1720 and set the belt length accordingly.
    However, in the software the stepper motors are displayed in the wrong place. I guess they are still 650 mm apart.
    Can I set the machine width in Makelangelo software 7.282? This was possible in previous versions as far as I remember.

    Any help is appreciated. Thanks!



    You did everything correctly.

    In ~7.29 I started to clean up a lot of code that was worked but was really poorly constructed. We have temporarily lost the ability to change the visual of the machine. I am actively working on adding that feature back in (see link below). I would love your help with making it happen.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.