how to configure GcodeCNCDemo2Axis for M542H drivers
- This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi at all,
I’m Italian and my English is not good, normally use the automatic translator and I hope you can understand me.I’m trying to use GcodeCNCDemo2Axis with my M542H stepper drivers. I would like to set up the Arduino’s sketch for generic driver’s like mine, then setting the pin number for dir / pulse / enable for each of the two stepper.
How can I do this?
Thanks in advance
GcodeCNCDemo2Axis has a separate file for each type of control board. Please study the existing files to determine what changes. I don’t have one of your boards so I can’t make the changes myself.
Good luck!
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
