how do i get optical endstopa to work on my rumba all in one board

Home Forum Everything Else how do i get optical endstopa to work on my rumba all in one board

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #11610
    AvatarAnonymous
    Inactive

    iv been trying to get my optical endstops to work on my rumba but at no success iv got my motor to move buy changing the pin outs to my firmware but I cannot seem to get the optical endstop to work if anyone has any advice please it would be greatly appreciated.

    #11612
    DanDan
    Keymaster

    like this?

    FWIW, this “colorful” board we would not recommend. I pulled it from the junk pile to do the endstop test. It arrived with headers missing and stepper motor behavior was less than ideal. We have better suppliers.

    #11615
    AvatarAnonymous
    Inactive

    Yes exaclt like that the light will turn off but the motor will not stop.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.