Help with Servo on Makelangleo 3.2
- This topic has 1 reply, 2 voices, and was last updated 5 years, 3 months ago by .
-
Posts
-
I can’t seem to get the pen servo to work on my brand new 3.2. I’m not sure that it is plugged into the correct place on the Rumba. Can someone tell me where it goes? I’ve searched google and I think maybe it goes on these pins?
My 3.2 came with this servo: http://www.ee.ic.ac.uk/pcheung/teaching/DE1_EE/stores/sg90_datasheet.pdf
Thank you!
https://reprap.org/wiki/File:RRD-RUMBA.JPG
In the bottom left corner there is a label that says “12v”. left of that is an triangle pointing down. the servo wire 3-pin connector should be connected one row down.
Here’s another picture that shows it connected. Note that (a) the black wire is on the right and (b) the two pins under “12v” are NOT connected to the servo wire.
On the other end of the cable…
cable black -> servo red
cable red -> servo brown
cable white -> servo yellow
- You must be logged in to reply to this topic.
