Command-line version of software
- This topic has 1 reply, 2 voices, and was last updated 10 years ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Is there a way to run the Makelangelo software to send GCode to the arduino from the command-line only?
The closest we have is gcodesender, which JUST sends gcode. it is not command-line friendly.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
