Arduino Uno R3 & CNC Shield V3.0

Home Forum Everything Else Arduino Uno R3 & CNC Shield V3.0

This topic contains 1 reply, has 0 voices, and was last updated by Avatar Anonymous 4 years, 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #6129
    Avatar
    Anonymous

    Hi!
    I’m newbie on CNC but I Intend to build a 4 axis hot wire foam CNC cutter.
    The installation instructions shows that is possible to use the GCodeCNCDemo with Arduino and Adafruit Motor Shield.
    As I have an Arduino Uno R3 and a CNC Shield V3.0 (http://blog.protoneer.co.nz/arduino-cnc-shield/) is it possible to use GCodeCNCDemo on it?
    Does It needs some kind of changes on code?
    Excuse me if they are stupid questions.

    #7139
    Avatar
    Anonymous

    I have never worked with that shield so I cannot 100% confirm.

    If it runs on an Arduino then yes, GcodeCNCDemo will work with some modifications.
    The code has specific files for each type of controller. You can look at the existing files to see what is similar, what is changed, and undertand how to make your controller work.

    If you get it working, send a github pull request and your changes will be added back into the project for everyone to enjoy.

    It sounds like an exciting project. Good luck!

    (PS: Send video when you get the cutter working)

    #7140
    Avatar
    Anonymous

    Thank you for your quick reply!
    I’ll try it..

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.