how do i get optical endstopa to work on my rumba all in one board
- This topic has 2 replies, 2 voices, and was last updated 7 years, 5 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
iv been trying to get my optical endstops to work on my rumba but at no success iv got my motor to move buy changing the pin outs to my firmware but I cannot seem to get the optical endstop to work if anyone has any advice please it would be greatly appreciated.
like this?
FWIW, this “colorful” board we would not recommend. I pulled it from the junk pile to do the endstop test. It arrived with headers missing and stepper motor behavior was less than ideal. We have better suppliers.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
