Halting a drawing causes unexpected behavior afterwards

Shop Forum Makelangelo Polargraph Art Robot Halting a drawing causes unexpected behavior afterwards

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #6100
    Anonymous
    Inactive

    Today I got my makelangelo up and printing for the first time!
    I was surprised to see that after I halted a print, the x and y buttons act as if they have been switched. If I reset the board, then everything is normal again. Does anyone else see this behavior?

    #7014
    Anonymous
    Inactive

    is X+ going X-?
    is X+ going Y+?

    #7015
    Anonymous
    Inactive

    From what I remembered, at least one was acting inverted. My two thoughts were that it could have “lost center” and was thus behaving erratically, or it could have been the buffer overflow I (tinyenormous) was tweeting about earlier.

    #7016
    Anonymous
    Inactive

    If only one stepper is inverted, fix it in the “jog motors” control panel.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.