Firmware with a Gen 6 Board
- This topic has 1 reply, 2 voices, and was last updated 8 years ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I’ve got an old Generation 6 Electronics Board from a 3D printer, just wondering if anyone has got this to work with the firmware? Any ideas are much appreciated.
http://reprap.org/wiki/Generation_6_Electronics
http://reprap.org/wiki/File:Gen_6_pins.pnglooks like a picture of the pins available on the gen6. Properly copied to the firmware you should be able to add a MOTHERBOARD_GEN6 with your board-specific settings. I don’t have a gen6 with which to test, but if you send a pull request once you’ve tested your change we’ll make sure the settings stay in future versions (updates from us won’t stomp on your additions)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
