• April 11, 2017 at 09:37 #12842

    Hello,

    I have tried running the Stewart platform with the code provided but only stepper 5 and stepper 6 are moving. Does anyone know why this is happening?

    Dan
    April 11, 2017 at 09:42 #12843

    Post a picture of your setup?

    April 12, 2017 at 07:15 #12849

    I have figured out the issue. I think 4 out of 6 drivers have burned out somehow so only 2 of the motors are working. I couldn’t figure out a way to post the picture of my set up but would I be able to buy the drivers alone through your website?

    April 12, 2017 at 07:16 #12850

    Is this board identical to the one that you have used in the Stewart platform?
    RUMBA Board incl. 6 A4988 driver and Wire Pack

    April 12, 2017 at 07:19 #12851

    I found the drivers: Set of (5) A4988 Pololu compatible driver
    Would I be able to use these to replace the drivers that you used in the Stewart platform? I apologize for my millions of emails

    April 12, 2017 at 07:21 #12852

    I just checked they’re the same haha I’m crazy.. Thank you!

    Dan
    April 20, 2017 at 17:01 #12896

    Yes, the A4988 drivers are what we use in the RUMBAS for the Stewart Platform.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.

0
Save & Share Cart
Your Shopping Cart will be saved and you'll be given a link. You, or anyone with the link, can use it to retrieve your Cart at any time.
Back Save & Share Cart
Your Shopping Cart will be saved with Product pictures and information, and Cart Totals. Then send it to yourself, or a friend, with a link to retrieve it at any time.
Your cart email sent successfully :)