• zlm0517
    March 20, 2015 at 03:39 #6092

    Hello. I have some problems with the< Stewart Platform 2> when upload the code you posted on the Github.
    At first, after assemble the platform, i uploaded the firmware_rumba_minimal then input the “G28” in the serial monitor, the motors moved slowly until touched the swiches respectively, the motors then move in reverse at the same time. at last, the biceps were all returns horizontal position.
    the motors had no response whatever i type, “G00 X5, M18, M17….”

    I have also uploaded the ” firmware_rumba ” , but the motor have no response even type the ” G28″ , I checked the hardware several times , i seems like no problems. could you tell me how to resolve it?
    thank you .

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

0
Save & Share Cart
Your Shopping Cart will be saved and you'll be given a link. You, or anyone with the link, can use it to retrieve your Cart at any time.
Back Save & Share Cart
Your Shopping Cart will be saved with Product pictures and information, and Cart Totals. Then send it to yourself, or a friend, with a link to retrieve it at any time.
Your cart email sent successfully :)