• i-make-robots
    October 7, 2013 at 19:10 #5937

    6 motors drawing 0.3 amps each should draw 1.8 amps, right? Right. Until… After about 15 minutes of run time the motors warm up and draw more than 2 amps. If you find that on long runs your control board is “browning out” – spontaneously resetting – then upgrade to a 3 amp power supply and it should be fixed.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

0
Save & Share Cart
Your Shopping Cart will be saved and you'll be given a link. You, or anyone with the link, can use it to retrieve your Cart at any time.
Back Save & Share Cart
Your Shopping Cart will be saved with Product pictures and information, and Cart Totals. Then send it to yourself, or a friend, with a link to retrieve it at any time.
Your cart email sent successfully :)