Makelangelo Graphic LCD
- This topic has 8 replies, 5 voices, and was last updated 6 years, 9 months ago by .
-
Posts
-
Just for fun, I decided to hook up a RepRap 128×64 graphic LCD. Here is what I have so far.
Its a work in progress, but I think its pretty cool. Now if I could just figure out why I’m losing step ?
Regards,
William
Woah William!!
Could you please share your firmware? Is the SD card working for you?
Very impressive.
Noah
Hello, I have tired making the Makelanglo 5 using the Rumba board and LCD display.. but i cant seem to get the LCD to display anything.. it turns on and i can see the knob interacting witht he board but otherwise i cant see what i am selecting.. any thoughts buddy..
I used the Rumba Firmware on this site.
@fishingcairns – you have the graphicLCD version from earlier in this thread? We didn’t write that version and haven’t seen the code. Official support does not exist yet.
How are you able to make suck high quality drawing? I am using and UNO and Adafruit driver and can’t even come close to this. I can’t even come close to this on the screen with the latest software from this site. Please let me know how I can make these improvements and how I can add the large reprap display to mine. I assume I will need to use a mega and compatible driver to add the connectors for the LCD.
Curt@curt locey which high quality drawing are you talking about? The LCD panel is a project some DIY people are working on.
- You must be logged in to reply to this topic.
